Not only will flux be used, it will also need to be managed! The use of flux is very extensive. In the process of application, it is necessary to do a good job of on-site management. Because welding work has certain dangers, the flux in the welding site must be reasonably managed and stored. What is the specific management of the flux? Let's take a look with the flux manufacturer.

       During the application of the flux, the parts to be welded must be cleaned up. Do not mix the debris into the flux. The flux including the flux pad must be distributed according to the rules. Kaiwei welding materials are recommended to be kept at about 50 ° C for use together. It is necessary to do a good job of flux recovery in time to prevent the flux from being contaminated. In addition, for continuous and repeated use of the flux, select the 8 mesh and 40 map sieve to separate the sieving, in order to eliminate the impurities and fines in it, when it is used again, it must be mixed with three times the new flux and used. Before use, it must be dried and kept at 250-350 ℃ for 2 hours. After drying, it should be kept in a 100-150 ℃ incubator for re-use and should not be stored in the open. If the situation of the flux site is more complicated or the relative environmental humidity is high, the management of the operation site must be done in a timely manner, the site must be kept clean, and the necessary flux resistance and mechanical mixture experiments must be performed to control the moisture absorption And mechanical inclusions, we must prevent the appearance of random piles, turbid flux and other scenes.

       For any job, the background management is very important, and the operation of the flux is also the same. In the application process, the on-site management work must be done well to ensure the smooth execution of the welding work.